Request a Free Roof Inspection →

Back to BlogMaintenance

Heat Cable for Ice Dams: What It Costs and How It Works in Southern Wisconsin

Nov 22, 20264 min read
Heat Cable for Ice Dams: What It Costs and How It Works in Southern Wisconsin

Every winter the same calls come in from Beloit, Janesville and the towns around them: a brown stain on the ceiling near an outside wall, icicles as long as a broom handle, and a ridge of ice frozen along the roof edge. That ridge is an ice dam, and once it forms, meltwater has nowhere to go but back up under your shingles.

Heat cable is one of the simplest ways to keep that from happening. Here's how it works, where it goes, what it can't do, and what it costs.

Why ice dams form

Heat from your house warms the roof and melts the snow on top of it. The water runs down to the eave, which hangs out past the warm walls and stays cold, so the water freezes again. Repeat that for a few days and the ice builds into a dam. The next round of melt pools behind it and gets pushed up under the shingles, into the roof deck and then your ceilings.

For more on the causes and warning signs, see Ice Dams 101.

What heat cable actually does

Heat cable doesn't melt all the snow on your roof. It keeps a clear channel open so meltwater drains away before it can refreeze.

  • On the roof edge: the cable runs in a zigzag along the eave, held by clips made for your roof. It keeps a path open through the ice right where dams form.
  • In the gutter: a run along the gutter keeps it from filling solid with ice.
  • Down the downspout: the cable runs all the way to the ground so the water has a way out at the bottom too. A heated roof edge that drains into a frozen downspout just moves the problem.

We install self-regulating cable (Radiant Solutions HeatTapePro). It puts out more heat when it's colder and less when it's milder, so it isn't running full blast on a 35-degree day.

Where it makes sense

Heat cable works best on the spots that dam up every winter:

  • North-facing eaves that never get sun
  • Valleys and the roof edges below them
  • Dormers and places where two roof lines meet
  • Low-slope rubber (EPDM) roofs, where we use glue-down clips so there are no holes in the membrane
  • Gutters and downspouts that freeze solid and send icicles down the siding

If your whole roof dams up every year, it's worth asking why. Many ice dams start with warm air leaking into the attic, or with thin insulation and poor ventilation. Heat cable manages the problem at the edge; fixing the attic deals with the cause. When we look at your roof, we'll tell you which one your house needs.

What it can't do

  • It's prevention, not removal. Cable keeps new ice from building. If you already have a big ice dam, it has to be dealt with safely first. Please don't go after it with a hammer from a ladder.
  • It needs power. The cable plugs into a GFCI-protected outdoor outlet. We check yours before we install, and if you need a new outlet, we tell you up front.
  • It goes on easiest before the snow. A clear, dry roof is the best time to install. We can still install on clear winter days, but fall is ideal.

What it costs

Our heat cable pricing is simple:

  • $55 per foot of roof edge you want protected, with the gutter and downspout runs included
  • $750 minimum
  • $45 per foot if you're getting a new roof from us, since the crew is already up there

A typical 40-foot run over the problem eaves comes to about $2,200. Measure the roof edge that ices up, multiply by $55, and you'll have a close number. We confirm the layout and the outlet location on site before anything goes up.

Compare that with what an ice dam can cost once water gets inside: wet insulation, stained drywall, and sometimes rotted roof deck along the edge.

How we install it

  1. Walk the roof with you and plan the cable and cord route
  2. Check that the outdoor outlet is GFCI-protected and the circuit has room
  3. Clear the gutters and downspouts the cable runs through
  4. Zigzag the cable along the roof edge with clips made for your roof
  5. Run it along the gutter and down each downspout to the ground
  6. Test the system and show you how to use it

Next step

See our heat cable service, price it yourself in Build My Price, or call or text (608) 897-5377 and we'll come look at where your ice builds.

Call Text